The two photos above show the top half of the game (right side) and bottom half (left side). The top half of the enclosure has not been completed yet due to the currently missing joystick. All that has been done is resistors soldered to pushbuttons and then connected to the breadboard. On the bottom half of the enclosure, many wires connect between the two chips, also connecting to a reset button and a power switch (on top). Another feature is that it is recharged with a basic phone charger (bottom left). As you can see, a few wires have not been connected to anything yet because those wires connect to the top half of the enclosure at the top of the breadboard where the four holes are in the center.
If you didn't already know, each solder on the breadboard and on the chips, has to be very accurate because they can NOT touch one another otherwise it may not work right.
If you didn't already know, each solder on the breadboard and on the chips, has to be very accurate because they can NOT touch one another otherwise it may not work right.